Pin 27 board makes the installation of a Filament Sensor or a BLTouch fast and easy on the Anet A8.
With this custom PCB no soldering is required and with an BLTouch you can enable auto bed levelling easily.
This is designed for version 1.5 of the Anet board where the spacing of the two connectors is close together. When the 1.5 board is used it only requires the passthrough of one connector which is done by the board.
Please be advised unless you have all components connected and the firmware flashed the screen may be blank until all steps are complete.
For a great installation video see https://www.youtube.com/watch?v=WWDkZtWwd6I
Please find a lot of mounts available on thingiverse https://www.thingiverse.com/thing:2091529