Introduction

With the introduction of the 550 and 5XL series, Dymo released new labels with a small RFID chip. This chip prevents the use of much cheaper 3rd party labels that used to work on their older models like the 450 and 4XL.

You can save up to 90% in label cost by using this chip.

How does it work

1) Install this chip between the RFID reader and the mainboard. 2) Configure the label type you would like to print. 3) Dymo connect will recognise this label as original. 4) Print your labels!

It's that simple. You can print an unlimited amount of 3rd party labels.

Can I still use original labels?

Yes! Since the RFID board is connected, as soon as you install an original roll of labels, the PrintFree module will recognise this roll and will make sure it is recognised by the labelwriter.

Which label types are supported?

The following labels are supported. Note that some labels are region locked. Only labels that are sold in your region will work in your printer.

• 1744907 -- 102 mm x 152 mm / 4 in x 6 in -- 220 pcs.
• 30252 -- 28 mm x 89 mm / 1.125 in x 3.5 in -- 350 pcs.
• 30256 -- 59 mm x 104 mm / 2.3125 in x 4 in -- 300 pcs.
• 30332 -- 25 mm x 25 mm / 1 in x 1 in -- 750 pcs.
• 30336 -- 25 mm x 51 mm / 1 in x 2.125 in -- 500 pcs.
• 30857 -- 57 mm x 104 mm / 2.25 in x 4 in -- 250 pcs.
• S0722400 -- 36 mm x 89 mm / 1.4 in x 3.5 in -- 50 pcs.
• S0722430 -- 54 mm x 101 mm / 2.125 in x 4 in -- 220 pcs.
• S0722540 -- 57 mm x 32 mm / 1.25 in x 2.25 in -- 1000 pcs.
• S0722550 -- 19 mm x 51 mm / 0.75 in x 2 in -- 500 pcs.
• S0904980 -- 104 mm x 159 mm / 4 in x 6 in -- 220 pcs.

Does it work with all 550 and 5XL printers?

At this moment it only works with printers manufactuered in January 2024 an before. For newer manufactured printers you will need to solder to pins on the mainboard to disable an onboard eeprom.

Orders are usually shipped once a week. Delivery depends on location.